Layer 3 Dynamic Aggregation Configuration Example - HP A6600 Configuration Manual

# Configure the global link-aggregation load sharing criteria as the source and destination IP addresses
of packets.
[RouterA] link-aggregation load-sharing mode source-ip destination-ip
Configure Router B
2.
Configure Router B using the same instructions that you used to configure Router A.
Verify the configurations
3.
# Display summary information about all aggregation groups on Router A.
[RouterA] display link-aggregation summary
Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e2ff-0001
AGG
Interface
-------------------------------------------------------------------------------
RAGG1
The output shows that link aggregation group 1 is a load-sharing-capable Layer 3 static aggregation
group that contains three selected ports.
# Display the global link-aggregation load sharing criteria on Router A.
[RouterA] display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Mode:
destination-ip address,
The output shows that the global link-aggregation load sharing criteria are the source and destination IP
addresses of packets.

Layer 3 dynamic aggregation configuration example

Network requirements
As shown in
Router A and Router B are connected by their Layer 3 Ethernet interfaces GigabitEthernet 4/1/1
•
through GigabitEthernet 4/1/3.
• Configure a Layer 3 dynamic aggregation group on Router A and Router B, respectively, and
configure IP addresses and subnet masks for the corresponding Layer 3 aggregate interfaces.
Enable traffic to be load-shared across aggregation group member ports based on source and
•
destination IP addresses.
AGG Partner ID
Mode
S none
source-ip address
Figure 10:
Select Unselect
Ports Ports
3 0
34
Share
Type
Shar