HP A6600 Configuration Manual page 201

[RouterA-behavior-b33] quit
[RouterA] qos policy p11
[RouterA-policy-p11] classifier c11 behavior b11
[RouterA-policy-p11] classifier c22 behavior b22
[RouterA-policy-p11] classifier c33 behavior b33
[RouterA-policy-p11] quit
[RouterA] qos policy p22
[RouterA-policy-p22] classifier c44 behavior b11
[RouterA-policy-p22] classifier c55 behavior b22
[RouterA-policy-p22] classifier c66 behavior b33
[RouterA-policy-p22] quit
# Assign customer-side port GigabitEthernet 4/1/1 to CVLANs 1 to 3, and SVLANs 101, 201, and 301,
and enable basic QinQ, and apply uplink policy p1 to the incoming traffic and downlink policy p1 1 to
the outgoing traffic.
[RouterA] interface gigabitethernet 4/1/1
[RouterA-GigabitEthernet4/1/1] port link-type trunk
[RouterA-GigabitEthernet4/1/1] port trunk permit vlan 1 2 3 101 201 301
[RouterA-GigabitEthernet4/1/1] qinq enable
[RouterA-GigabitEthernet4/1/1] qos apply policy p1 inbound
[RouterA-GigabitEthernet4/1/1] qos apply policy p11 outbound
[RouterA-GigabitEthernet4/1/1] quit
# Assign customer-side port GigabitEthernet 4/1/2 to CVLANs 1 to 3, and SVLANs 102, 202, and 302,
enable basic QinQ, and apply uplink policy p2 to the incoming traffic and downlink policy p22 to the
outgoing traffic.
[RouterA] interface gigabitethernet 4/1/2
[RouterA-GigabitEthernet4/1/2] port link-type trunk
[RouterA-GigabitEthernet4/1/2] port trunk permit vlan 1 2 3 102 202 302
[RouterA-GigabitEthernet4/1/2] qinq enable
[RouterA-GigabitEthernet4/1/2] qos apply policy p2 inbound
[RouterA-GigabitEthernet4/1/2] qos apply policy p22 outbound
[RouterA-GigabitEthernet4/1/2] quit
# Assign network-side port GigabitEthernet 4/1/3 to all SVLANs.
[RouterA] interface gigabitethernet 4/1/3
[RouterA-GigabitEthernet4/1/3] port link-type trunk
[RouterA-GigabitEthernet4/1/3] port trunk permit vlan 101 201 301 102 202 302
Packets sent by PCs are VLAN untagged. If a PC is directly attached to a wiring-closet router, configure
the port on the router as an access or trunk port:
• If the port is configured as an access port, assign it to the SVLAN.
• If the port is configured as a trunk port, specify the SVLAN as the default VLAN.
194