HP A6600 Configuration Manual page 195

Perform these tasks to configure two-to-two VLAN mapping:
Task
Configuring an uplink policy for the
customer-side port
Configuring an uplink policy for the
network-side port
Configuring a downlink policy for the
customer-side port
Configuring the customer-side port
Configuring the network-side port
Configuring an uplink policy for the customer-side port
The uplink policy on the customer-side port modifies the SVLAN ID of incoming traffic.
To configure an uplink policy for the customer-side port:
To do...
1. Enter system view
2. Create a class and enter class
view
3. Specify a foreign CVLAN as a
match criterion
4. Specify a foreign SVLAN as a
match criterion
5. Return to system view
6. Create a traffic behavior and enter
traffic behavior view
7. Configure an SVLAN marking
action to replace the foreign
SVLAN ID with a local SVLAN ID
8. Return to system view
9. Create a QoS policy and enter
QoS policy view
10. Associate the class with the
behavior
Description
Replaces foreign SVLANs with local SVLANs for uplink traffic
(required).
Replaces foreign CVLANs with local CVLANs for uplink traffic
(required).
Replaces local SVLANs and CVLANs with foreign SVLANs and
CVLANs (required).
Configures VLAN and other settings required for two-to-two VLAN
mapping (required).
Configures VLAN and other settings required for two-to-two VLAN
mapping (required).
Use the command...
system-view
traffic classifier tcl-name [ operator
and ]
if-match customer-vlan-id vlan-id
if-match service-vlan-id vlan-id
quit
traffic behavior behavior-name
remark service-vlan-id vlan-id
quit
qos policy policy-name
classifier tcl-name behavior
behavior-name
188
Remarks
—
Required.
Repeat these steps to
create one class for each
foreign CVLAN and
SVLAN pair.
Required.
Repeat these steps to
configure one SVLAN
marking action for each
CVLAN and SVLAN pair.
Required.
Required.
Repeat this step to create
other class-behavior
associations.