Layer 2 Dynamic Aggregation Configuration Example - HP A6600 Configuration Manual

Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e2ff-0001
AGG
Interface
-------------------------------------------------------------------------------
BAGG1
The output shows that link aggregation group 1 is a load shared Layer 2 static aggregation group and it
contains three selected ports.
# Display the global link-aggregation load sharing criteria on Router A.
[RouterA] display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Mode:
destination-mac address, source-mac address
The output shows that all link aggregation groups created on the router perform load sharing based on
source and destination MAC addresses.

Layer 2 dynamic aggregation configuration example

Network requirements
As shown in
Router A and Router B are connected through their respective Layer 2 Ethernet interfaces
•
GigabitEthernet 3/1/1 through GigabitEthernet 3/1/3.
• Configure a Layer 2 dynamic aggregation group on Router A and Router B, respectively. Enable
VLAN 10 at one end of the aggregate link to communicate with VLAN 10 at the other end, and
VLAN 20 at one end to communicate with VLAN 20 at the other end.
Enable traffic to be load-shared across aggregation group member ports based on source and
•
destination MAC addresses.
Figure 7 Network diagram for Layer 2 dynamic aggregation
AGG Partner ID
Mode
S none
Figure 7:
Select Unselect
Ports Ports
3 0
28
Share
Type
Shar