One-To-Two And Two-To-Two Vlan Mapping Configuration Example - HP A6600 Configuration Manual

Configuring Router B
2.
Configure Router B in the same procedure as on Router A.
One-to-two and two-to-two VLAN mapping configuration
example
Network requirements
As shown in
Two VPN A branches, Site 1 and Site 2, are in VLAN 10 and VLAN 30, respectively. The two site
•
use different VPN access services of different service providers, SP 1 and SP 2. SP 1 assigns VLAN
100 for Site 1, and SP 2 assigns VLAN 200 for Site 2.
Configure one-to-two and two-to-two VLAN mappings to enable the two branches to communicate
•
across networks SP 1 and SP 2.
The routers are installed with SAP high-density interface cards that work in Layer 2 mode.
•
Figure 73 Network diagram for the one-to-two and two-to-two VLAN mapping application
Configuration procedure
Configuring PE 1
1.
# Configure an uplink policy test to add outer VLAN tag 100 to VLAN 10 tagged traffic.
<PE1> system-view
[PE1] traffic classifier test
[PE1-classifier-test] if-match customer-vlan-id 10
[PE1-classifier-test] quit
[PE1] traffic behavior test
[PE1-behavior-test] nest top-most vlan-id 100
[PE1-behavior-test] quit
[PE1] qos policy test
[PE1-qospolicy-test] classifier test behavior test
[PE1-qospolicy-test] quit
# Configure customer-side port GigabitEthernet 4/1/1 as a hybrid port, and assign it to VLAN 100 as
an untagged member, so the port forwards VLAN 100 traffic with the VLAN tag removed. On the port,
enable basic QinQ, and apply uplink policy test to the incoming traffic.
[PE1] interface gigabitethernet 4/1/1
Figure 73:
195