HP A6600 Configuration Manual page 117

Configuring a super VLAN
To configure a super VLAN:
To do...
1. Enter system view
2. Enter VLAN view
3. Configure the VLAN as a
super VLAN
4. Associate the super VLAN
with the specified sub-VLANs
Configure a VLAN interface for the super VLAN
To configure a VLAN interface for the super VLAN:
To do...
1. Enter system view
2. Create a VLAN interface, and
enter VLAN interface view
3. Configure the IP address of
the VLAN interface
4. Enable local proxy ARP
Configure the IP address of the VLAN interface with that of the corresponding super VLAN.
For more information about the local proxy ARP function, see Layer 3—IP Services Configuration Guide.
For more information about the local-proxy-arp enable command, see Layer 3—IP Services Command
Reference.
You cannot configure a super VLAN as the guest VLAN for a port, and vice versa. For more information
about guest VLANs, see Security Configuration Guide.
Configure Layer 2 multicast for a super VLAN. However, the configuration cannot take effect.
Configure DHCP, Layer 3 multicast, dynamic routing, and NAT for the VLAN interface of a super VLAN.
However, only DHCP takes effect.
Configuring VRRP for the VLAN interface of a super VLAN affects network performance. HP does not
recommend you to configure this function in normal cases. For more information about VRRP, see High
Availability Configuration Guide.
You cannot configure subinterfaces on the VLAN interface of a sub-VLAN.
Use the command...
system-view
vlan vlan-id
supervlan
subvlan vlan-list
Use the command...
system-view
interface vlan-interface
vlan-interface-id
ip address ip-address { mask |
mask-length } [ sub ]
local-proxy-arp enable
110
Remarks
—
Required.
If the specified VLAN does not
exist, this command creates the
VLAN first, and then enters VLAN
view.
Required.
Required.
VLANs specified by vlan-list must
be the sub-VLANs configured
earlier.
Remarks
—
Required.
The value of vlan-interface-id must
be the ID of the super VLAN.
Required.
By default, the IP address of a
VLAN interface is not configured.
Required.
By default, local proxy ARP is
disabled.