HP A6600 Configuration Manual page 42

Figure 10 Network diagram for Layer 3 dynamic aggregation
Configuration procedure
Configure Router A
1.
# Create Layer 3 aggregate interface Route-aggregation 1, configure the link aggregation mode as
dynamic, and configure an IP address and subnet mask for the aggregate interface.
<RouterA> system-view
[RouterA] interface route-aggregation 1
[RouterA-Route-Aggregation1] link-aggregation mode dynamic
[RouterA-Route-Aggregation1] ip address 192.168.1.1 24
[RouterA-Route-Aggregation1] quit
# Assign Layer 3 Ethernet interfaces GigabitEthernet 4/1/1 through GigabitEthernet 4/1/3 to
aggregation group 1.
[RouterA] interface gigabitethernet 4/1/1
[RouterA-GigabitEthernet4/1/1] port link-aggregation group 1
[RouterA-GigabitEthernet4/1/1] quit
[RouterA] interface gigabitethernet 4/1/2
[RouterA-GigabitEthernet4/1/2] port link-aggregation group 1
[RouterA-GigabitEthernet4/1/2] quit
[RouterA] interface gigabitethernet 4/1/3
[RouterA-GigabitEthernet4/1/3] port link-aggregation group 1
[RouterA-GigabitEthernet4/1/3] quit
# Configure Router A to use the source and destination IP addresses of packets as the global
link-aggregation load sharing criteria.
[RouterA] link-aggregation load-sharing mode source-ip destination-ip
Configure Router B
2.
Configure Router B using the same instructions that you used to as you configure Router A.
Verify the configurations
3.
# Display summary information about all aggregation groups on Router A.
[RouterA] display link-aggregation summary
Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e2ff-0001
AGG
Interface
-------------------------------------------------------------------------------
RAGG1
AGG Partner ID
Mode
D 0x8000, 000f-e2ff-0002
Select Unselect
Ports Ports
3 0
35
Share
Type
Shar