Communicator ® Battery-Release Latch - HME Wireless 6000 Installation Instructions Manual

5. Battery Removal and Replacement
Battery-release
latch
®
Figure 6. COMMUNICATOR battery-release latch
TO CHANGE BATTERIES: When a battery is becoming weak, a voice in the earpiece
will say "Change battery." When this happens, take the Communicator out of its pouch
and remove its battery by carefully sliding the battery-release latch in the direction of
the arrow shown in Figure 6. Pull up on the end of the battery near the battery-release
latch and lift the battery out of the Communicator, or turn the Communicator over and
catch the battery in your hand.
TO REPLACE BATTERIES: When replacing a battery in the Communicator, place the
end of the battery with the metal contacts into the battery holder on the Communicator,
in the same position as the battery you removed. Press the top of the battery carefully
into the battery holder until it snaps in place under the battery-release latch.
6