Figure E-3. Installing gasket and bracket
•
Position the DM1 Microphone unit
between the sides of the bracket and
align the two holes in the unit with the
two slots on the bracket. Fasten the
unit in place with two of the four
remaining lock washers and screws,
inserting the screws into the holes
toward the rear of the microphone
as shown in Figure E-5.
•
Pull any slack cable down below the
mounting surface, leaving just enough
to position the microphone as
required, and tighten the nut on the
strain relief below the microphone as
seen in Figure E-5.
•
Strip and splice the color-coded wires
of the existing microphone cable to
the corresponding color-coded wires
of the DM1 Microphone cable. Solder
all splices and cover them with
electrical tape or heat shrink tubing.
Figure E-4. Routing cable through strain relief
Figure E-5. Mount microphone on bracket
41