Base Station; Wireless 6000 Base Station - HME Wireless 6000 Installation Instructions Manual

1.2.1

Base Station

Front — (See A on Figure 2.)
•
Four power supply lights are on when the base station has AC power.
•
"A" TALK light is on during channel-A transmission.
•
"B" TALK light is on during channel-B transmission.
•
VEHICLE PRESENT light is on when a vehicle is present in the drive-thru lane or when
the system is in vehicle-detect override.
•
RECORD light is ON RED when the base station is ready to record red message for the
message repeater, and BLINKING RED while red message is being recorded. It is ON
GREEN when the base station is ready to record green message for the message
repeater, and BLINKING GREEN while green message is being recorded.
Bottom — (See B on Figure 2.)
•
PUSH FOR RECORD MODE button must be pushed IN AND RELEASED ONCE to
prepare the base station to record red message for the message repeater, or pushed
IN AND RELEASED TWICE to record green message.
Behind Front Door — (See C on Figure 2.)
•
MESSAGE REPEATER switches must be switched ON to use the message repeater,
OFF when the message repeater is not being used. Instructions are given inside of the
front door.
•
SPEED TEAM switch must be switched ON for speed-team operation, OFF for normal
drive-thru operation
•
VEHICLE DETECTOR switch must be switched to OVERRIDE to disable vehicle
detector; to reset vehicle detector, switch to OVERRIDE for 5 seconds, then switch back
to NORMAL and leave for normal vehicle detection operation.
•
DIP switches at the top are used to control message audio routing to the speakers and
COMMUNICATOR
•
Nine level controls are used to set VAA level, Vehicle tone level, audio source levels at
the grill speaker, outbound audio source levels at the outside speaker and the inbound
level from the speaker post microphone.
®
s. DIP switch settings are shown on the inside of the front door.
A
B
Figure 2. Wireless 6000 Base Station
2
C