HME Wireless 6000 Installation Instructions Manual page 7

3. How to Use the COM6000BP COMMUNICATOR
The Communicator control buttons have a snap action. They will activate when
pressed firmly. Use your fingertips, not your fingernails, to press the buttons.
a. Power On/Off
•
Power On – Press and release the PWR (power) button. A voice message
in the earpiece will say "power on," and the red power lights next to the A1
and A2 buttons on the Communicator will go on. After a short time, one light
will go off and the other will change to green, indicating the Communicator is
ready to use. The voice message will say "Lane 1 (or 2) ready." In dual-lane
operations, a green light next to A1 indicates ready on Lane 1, next to A2
indicates ready on Lane 2.
•
Power Off – Press and hold the PWR button for approximately two seconds.
A voice message in the earpiece will say "power off," and the power lights will
go off.
b. Volume Up/Down
•
Volume Up Adjustment – Press and release the volume-up
Each time it is pressed, a beep will be heard in the earpiece as the volume
increases one step. When maximum volume is reached, "maximum" will be
heard in the earpiece. If you press and hold the volume-up button, repeating
beeps will be heard as the volume steps up to maximum. "Maximum" will be
heard in the earpiece, and will be repeated until you release the volume-up button.
•
Volume Down Adjustment – Press and release the volume-down
Each time it is pressed, a beep will be heard in the earpiece as the volume
decreases one step. When minimum volume is reached, a double beep will
be heard. If you press and hold the volume-down button, repeating beeps will
be heard as the volume steps down to minimum.
4
®
Controls
button.
button.