Keep in mind that the SP2500LP must
be mounted at least 2 feet (610 mm)
from the microphone, center-to-center.
•
Hold the rear panel of the
SP2500LP flat against the surface
of the speaker post or menu
board, at the desired mounting
location, as shown in Figure 16.
Use a pencil to mark the speaker
post through the wire hole in the
panel. Remove the panel and set it
aside. Drill a ¼ inch (6 mm) wire
hole at the marked location.
•
Hold the rear panel against the
surface, in the same position as
before, and screw the four
enclosed self-tapping screws
through each of the screw holes
on the panel, into the speaker post
or menu board as shown in Figure 17.
•
Route the cable from the back of the
speaker through the wire hole in the
rear panel of the speaker assembly,
into the speaker post. Close the
speaker assembly box by pressing it
tightly against the rear panel.
SP2500LP Cable Connections:
•
Inside the speaker post or menu
board, connect the green and white
wires of the appropriate cable to the
wires coming from the speaker as
shown in Figure 18. Do not connect
the drain wire. Solder the connection
and cover it with electrical tape or
shrink tubing.
IMPORTANT: For full-duplex systems, use separate cables for speaker and
microphone, or feedback may occur.
Figure 18. SP2500LP cable connections
Figure 16.
Mark speaker post or menu board
through wire hole in rear panel
of SP2500LP speaker assembly
Figure 17.
Screw the self-tapping screws
through holes in rear panel of
SP2500LP speaker assembly
15