Internal Message Repeater Setup; Early Warning Setup; Dual-Lane Setup; 2.3.10 Split-B Audio Setup - HME Wireless 6000 Installation Instructions Manual

2.3.7

Internal Message Repeater Setup

Locate and set the "Red Message" and "Green Message" slide switches and the "Red
Message Control" and "Green Message Control" DIP switches on the front panel of the base
station. Refer to page 22 for "Red Message Control" and "Green Message Control" switch
functions and message recording instructions.
If a System 30 Timer is installed with the Wireless 6000, the timer alert output can be
used to trigger tones in the headset or a message to be played by the message repeater.
Set "Red Message Control" and/or "Green Message Control" #5 switch to ON for an alert
tone (double beep), which will be heard only in headsets, or OFF for recorded messages to
be heard through outside speakers and/or headsets selected with the #2, 3 and 4 switches.
If Wireless 6000 message repeater will not be triggered by an external device, set both
"Red Message Control" and "Green Message Control" #5 switches to OFF so the message
repeater input will be triggered only by vehicle detector signals.
2.3.8

Early Warning Setup

An extra vehicle detector can be used with the Wireless 6000 to give a pre-warning signal
when a vehicle is entering the drive-thru area. To set up a pre-warning signal, first install the
extra vehicle detector at the desired detection point then connect its cable to connector J9,
positions 1 and 2 on the base station audio circuit board. If a second internal Vehicle
Detector Board is used, connect its P1 to J15 on the Audio Circuit Board. Wire J25, #8 and
9 to J9, #1 and 2 respectively.
2.3.9

Dual-Lane Setup

To set up the Wireless 6000 system for dual-lane operation, place K1 DIP switch #1 on the
base station transceiver board in the ON position, then press the "Reset" button. Refer to
Figure 25 on page 30.

2.3.10 Split-B Audio Setup

Split-B audio is used in dual-lane operations to limit audio transmission from Lane 1
COMMUNICATOR
transmission from Lane 2 Communicators to be heard only by other Lane 2 Communicator
operators. When the Split-B audio feature is not used, B audio transmission from either lane
is heard by all Communicator operators in both lanes.
To set up the Wireless 6000 system for split-B audio operation, place K1 DIP switch #2 on
the base station transceiver board in the ON position, then press the "Reset" button. Refer
to Figure 25 on page 30.

2.3.11 Auto-Hands-Free Setup

Auto-Hands-Free operation is explained on page 4. To set up the Wireless 6000 system for
auto-hands-free operation, place K1 DIP switch #3 on the base station transceiver board in
the ON position, then press the "Reset" button. Refer to Figure 25 on page 30.
®
s to be heard only by other Lane 1 Communicator operators, and
18