Communicator; Registration Button And Indicators - HME Wireless 6000 Installation Instructions Manual

4. COMMUNICATOR

Prior to operation of the Wireless 6000 system, each Communicator must be registered for
use with a specific base station. The base station will then recognize all registered
Communicators when their power is on, differentiating between them and interfering
transmissions from other electronic equipment operating on similar frequencies.
Register each Communicator as follows:
•
Be certain all Communicators to be registered are powered off and the base station
power is on.
•
Open the base station and press the registration button near the lower-left corner of the
base station circuit board shown in Figure 5.
⎯ If no Communicators are powered on, the status light shown in Figure 5 will be blinking
red. If any Communicators are powered on, the status light will be blinking green.
⎯ After you press the registration button, the Communicator ID display will show a
small "o" for open.
•
Press and hold the B button while pressing and releasing the PWR (power) button to
turn the Communicator on, then release the B button. This will cause the Communicator
to enter the registration mode.
⎯ The status light in the base station will be blinking green, and the Communicator ID
display will continue to show a small "o" for open.
⎯ The power lights next to the A1 and A2 buttons on the Communicator will be
blinking red then will change to green.
When the registration is successfully completed:
⎯ The green status light in the base station will be on steady and the Communicator
ID display, to the left of the status light, will show the ID number assigned to this
Communicator. ID numbers are assigned sequentially as 0 thru 9, A, b, C, d and E.
⎯ One of the power lights on the Communicator will remain on steady green.
Reset button
Figure 5. Registration button and indicators
NOTE: A maximum of 15 Communicators can be registered. If a Communicator is
replaced, the new one must be registered, but the old one remains in memory. If the
maximum number of 15 is exceeded, all current registrations must be cleared, and all
active Communicators must be re-registered. To clear all current registrations, press
the "Clear All Registration" button and the "Reset" button simultaneously. Continue
holding the "Clear All Registration" button after releasing the "Reset" button, until the
clear code "c" (lower case) appears on the Communicator ID display. All active
Communicators can then be registered, one at a time.
®
Registration
Communicator ID display
Status light
Clear All
Registration button
Registration button
5