Attach Mounting Bracket; Install Strain Relief; Dm1 Microphone Mounted On Top Of Menu Board - HME Wireless 6000 Installation Instructions Manual

To install the DM1 Microphone on the outside of a menu board, use the menu-board
mounting bracket to mount the DM1 as follows.
•
Disconnect the microphone cable from the
existing SP2000A Microphone Unit or SP2000D
Speaker/Microphone in the menu board.
•
Determine the best location for mounting the
DM1 Microphone on the outside of the menu
board. For best performance, it should be 42
to 46 inches (1.07 to 1.17 meters) above the
drive-thru lane.
•
Attach the menu-board mounting bracket to the
DM1 as shown in Figure E-7.
•
Install the strain relief on the menu board
mounting bracket as shown in Figure E-8, and
route the cable through the strain relief. Pull
any slack cable down through the bracket,
leaving just enough to allow the microphone to
be rotated up and down, and tighten the nut on
the strain relief below the microphone.
Figure E-8. Install strain relief
•
Mount the microphone on the menu board
as shown in Figure E-9.
•
Install the windscreen on the microphone as
shown in Figure E-6.
•
Strip and splice the DM1 cable wires to the
audio (microphone) cable wires coming
through the conduit from the building,
according to the color codes shown on the
appropriate wiring diagram in Figures E-10
and E-11. Solder all splices and cover them
with electrical tape or heat shrink tubing.
Figure E-7. Attach mounting bracket
Figure E-9. DM1 Microphone
mounted on top of menu board
43