Optional Equipment; Batteries In Charger - HME Wireless 6000 Installation Instructions Manual

3. Battery Charging
•
Insert battery in one of four charging ports until it clicks in place.
•
Battery charging time is approximately 2 hours.
•
Yellow light next to each battery port stays on while port is empty.
When battery is in port, yellow light flashing next to battery port indicates
CHARGE PENDING, which means the temperature where the charger is
located is out of the battery's operating range (32
Adjust the room temperature or move the charger to a cooler area.
When battery is in port, yellow light on steady next to battery port means
CHARGE FAILED. Follow diagnostic instructions on side of battery charger.
•
Red CHARGING light next to battery port stays on while battery is charging.
•
Green READY light next to battery port goes on when battery is fully charged.
•
Store fully charged batteries in storage ports.
CAUTION: Do not remove batteries from the charger until the green READY
light is lit, or the charger will reset and the charge cycle will begin again.
Battery in
storage port
1.3

OPTIONAL EQUIPMENT

COMMUNICATOR
Battery for COM6000BP
Headset Earmuff
Ceiling Speaker
Ultrasonic Vehicle Detector
Vehicle Detector Board
Vehicle Detector Loop (underground)
Message Repeater
Low-Profile Speaker
Microphone
Mode Switch (dual lane)
Switcher Circuit Board
Remote Record Switch
Remote Antenna Kit
Remote Speed Team Switch
Figure 9.

Batteries in charger

Equipment
®
o
-104
Battery in
charging port
8
o o o
F, 0 -40 C).
Model Number
COM6000BP
BAT40
No model number
MM100
DU3
VDB101A
VDL100
MR300
SP2500LP
DM3
MS1000
No model number
No model number
No model number
SW2