Battery Charger; Battery Charger Ac Adapter Connection; 230Vac Adapter Wiring For Battery Charger - HME Wireless 6000 Installation Instructions Manual

1.2.3

Battery Charger

IMPORTANT: Before installing the system, connect the AC adapter to the battery
charger and plug it into an AC electrical outlet. Place all the COMMUNICATOR
batteries into it for charging while the system is being installed.
1. Charger Setup
Connect the battery charger cable to the 16.5VAC adapter as shown in Figure 7.
Plug the adapter into an AC electrical outlet and secure it to the outlet with the
grounding screw (if provided). The red lights will come on and go off, then the yellow
lights will come on and stay on.
2. 230 Volt AC Adapter Connections Outside the U.S.A.
•
Connect an electrical plug to the wires on the power cable according to color
codes (Brown = live, Blue = neutral, Green with yellow stripes = ground).
•
Plug the other end of the power cable into the receptacle on the AC adapter.
•
Remove the spade lugs from the brown and blue wires of the battery charger
cable and cut the green/yellow wire as short as possible. No ground wire will be
used. Cut the connector off the AC adapter output cable. Strip enough of the
insulation from the wires of both cables so they can be spliced. Splice the wires
from the AC adapter cable to the "AC" wires of the battery charger cable. Cover
the splice with electrical tape or shrink tubing.
•
Plug the electrical plug into an AC electrical outlet.
Figure 7.

Battery charger AC adapter connection

Figure 8. 230VAC adapter wiring for battery charger
16.5VAC adapter
AC40
Battery Charger
7
®