Message Repeater Operation - HME Wireless 6000 Installation Instructions Manual

3.3.4

Message Repeater Operation

To record
Red
Message
To record
Green
Message
Locate the "RED MESSAGE" and "GREEN MESSAGE" slide switches, and the "RED MESSAGE
CONTROL" and "GREEN MESSAGE CONTROL" DIP switches inside the front door of the base
station for the following settings.
RED MESSAGE switch in the ON position enables the "RED MESSAGE" to be played.
A playing message can be cancelled by pressing Communicator button A.
RED MESSAGE CONTROL
Switch 1 enables inbound audio from speaker post to be heard while message is playing.
Switch 2 enables message to be played to all Communicators.
Switch 3 enables message to be played on the outside speaker.
Switch 4 enables message to be played on the ceiling speaker.
Switch 5 causes message to be triggered by an external alert signal.
Switches 6, 7 and 8 not used
GREEN MESSAGE switch in the ON position enables the "GREEN MESSAGE" to be played.
A playing message can be cancelled by pressing Communicator button A.
GREEN MESSAGE CONTROL
Switch 1 enables inbound audio from speaker post to be heard while message is playing.
Switch 2 enables message to be played to all Communicators.
Switch 3 enables message to be played on the outside speaker.
Switch 4 enables message to be played on the ceiling speaker.
Switch 5 causes message to be triggered by an external alert signal.
Switch 6 causes a 3 second delay before message is played.
Switch 7 not used
Switch 8 allows selection of a single-beep alert tone or two short beeps.
If both RED MESSAGE and GREEN MESSAGE switches are in the ON position, Red Message
and Green Message will be played alternately.
After a new message has been recorded or after the base station has lost and regained
power, any message to the outside speaker will always be heard in the Communicator
headset the first three times it plays.
ACTION
Press and release the RECORD MODE
button on the base station once.
Press and hold button B on the
®
COMMUNICATOR and talk into the
headset microphone to record a
message (up to 8 seconds).
Release button B.
Press and release the RECORD MODE
button on the base station twice.
Press and hold button B on the
Communicator and talk into the
headset microphone to record a
message (up to 8 seconds).
Release button B.
22
RESULT
The RED MESSAGE RECORD light
on the base station will come on.
The MESSAGE RECORD light on the
base station will begin blinking.
The record function will stop and the
MESSAGE RECORD light will go off.
The GREEN MESSAGE RECORD
light on the base station will come on.
The MESSAGE RECORD light on the
base station will begin blinking.
The record function will stop and the
MESSAGE RECORD light will go off.