APPENDIX D:
SP2000A SPEAKER/MICROPHONE INSTALLATION
Installation
Drill four c inch (3.2 mm) pilot holes at the spots shown
on Figure D-1 A, in the flange of the SP2000A.
Hold the enclosed SP2000A mounting template against
the outside of the speaker grill on the speaker post or
menu board, at the desired location. With a pencil or
other sharp object, mark the speaker grill through the
four drill-hole targets on the template. Drill a
/
inch
3
16
(4.8 mm) hole at each of the marked spots.
Hold the SP2000A flush against the inside of the
speaker grill, with the four pilot holes on its flange
directly over the four holes drilled through the grill
speaker. From the outside of the speaker grill, drill the
four enclosed self-tapping screws through the drilled
holes in the speaker grill and through the SP2000A
flange at each pilot hole, as shown in Figure D-1 B.
Figure D-1. Installing the SP2000A
Cable Connections
CAUTION: Never run high-voltage cables in the same conduit with audio or loop cables.
Connect the red wire from the appropriate cable to the white SP2000A wire, and the black cable
wire to the black SP2000A wire as shown in Figure D-2. Do not connect the drain wire. Solder the
connection and cover it with electrical tape or shrink tubing. Solder all splices to prevent
deterioration of performance.
Figure D-2. SP2000A cable connections
38