SciCan STATIM 7000 Operator's Manual page 31

6. The Communication Port
6. The Communication Port
Step 3
Setting Unit ID
UNIT ID
Note: Set the unit ID according to section 3.9.
Step 4a
Connecting the SciCan Data Logger or Serial Printer to the RS232 port on the back
of the unit
Ensure that both the Statim unit and the SciCan Data Logger or printer are OFF.
1.
2. Connect the SciCan Data Logger or printer to the Statim unit by using the serial cable.
3. Power up the SciCan Data Logger or printer.
4. Power up the Statim unit.
5. If connecting the Data Logger, the LCD will display
the following sequence of messages:
6 .. If connecting the Data Logger, insert USB Flash Drive
or SD memory card.
7. After a few seconds the LCD will display the
following sequence of messages:
Step 4b
Connecting the USB Flash Drive to the front USB Port
1. Power off the Statim unit
2. Power up the Statim unit
3. The LCD will display the sequence of messages as shown in Step 4a 5).
4. Insert the USB Flash Drive
5. After a few seconds the LCD will display the message as shown in Step 4a 7).
001
31
STATIM 7000 Operator's Manual
HH:MM DD/MM/YYYY
"MSD NOT DETECTED"/"INSERT
MSD/FLASH"/"SELECT A CYCLE"
HH:MM DD/MM/YYYY
USB/FLASH DETECTED/SAFELY
REMOVE MSD/SELECT A CYCLE