Connecting The Condenser And Waste Bottles - SciCan STATIM 7000 Operator's Manual

3. Installation
3. Installation

3.3 Connecting The Condenser and Waste Bottles

There are two bottles that need to be connected to the Statim 7000: the condenser bottle and
the waste bottle.
1. The condenser bottle includes a lid with 3 connectors (2 large fittings and 1 small
fitting) and a long copper condenser coil assembly.
2. The waste bottle includes the lid with 1 connector (1 small fitting) and a short copper
condenser coil.
NOTE: Do not mix the bottles and parts as this
could cause an overflow!
To connect the two bottles to the Statim 7000,
follow these steps:
1. Insert the 2 exhaust tubes onto the unit
exhaust tube ports and connect tightly.
2. Remove the 2 ferrule nuts from the large
fittings on the bottle with 3 connectors
and slide one nut onto each free end of
the exhaust tubes. Do not coil the
exhaust tubes.
3. Insert the exhaust tubes into the large
fittings and hand tighten the 2 ferrule
nuts.
4. Locate and remove the nut from the
small fitting on the bottle lid.
5. Slide the nut onto one end of the quick
coupling tubing.
6. Insert the tube into the small fitting and securely tighten.
7. Completely fill the condenser bottle with water and replace the lid.
8. Locate and remove the nut from the waste bottle (bottle with small condenser coil).
9. Slide the nut over the free end of the quick connect tubing.
10. Insert the tube into the waste bottle fitting and securely tighten.
11. Leave the waste bottle empty.
12. Place both bottles near and below the unit.
13. Replace the water in the bottles according to the Preventative Maintenance Schedule
to avoid unpleasant odours and discolouration of the contents. A low level disinfectant,
prepared to the manufacturer's instructions, may be added to remedy this situation.
Figure 3
Quick Coupling
Tubing
Waste Bottle
7
STATIM 7000 Operator's Manual
Exhaust Tube
Ports
Connector Tubing
Condenser Bottle