Cycle Printout Overview - SciCan STATIM 7000 Operator's Manual

STATIM 7000 Operator's Manual
6. The Communication Port

6.3 Cycle Printout Overview

1. Model: STATIM 7000
software: S702R604
2. Unit Identifier: autoclave has been
set up as number 000
3. Cycle counter: the number of cycles
having been run on the unit = 558
4. Time / Date: 11:07 am 17th May, 2007
5. Cycle Name: UNWRAPPED
6. Cycle Name cont'd – parameters:
134°C / 3.5 min
7. Cycle clock: starting at 0:00
8. Warm up complete: start of the
conditioning phase is 3:14 (see cycle
graph – 'A' phase complete, start of
'B' phase)
9. Start Time of Pressurization: 15:44
(start of 'C' phase)
10. Start Time of Sterilization: 20:36
(start of 'D' phase)
11. Temp. / Press. & Time at start of
sterilization ('D' phase)
12. Temp. / Press. & Time every 30
seconds during sterilization phase
(phase D))
13. Temp. / Press. & Time of end of
sterilization phase (end of 'D' phase)
14. Time Venting started: 24:07 (start of
'E' phase)
15. Time Air Drying started: 25:13
(start of 'F' phase)
16 .. Cycle Complete
1.
2.
3.
4.
5.
6 ..
7.
8.
9.
10.
11.
12.
13.
14.
15.
16 ..
32
6. The Communication Port