Shipping The Unit - SciCan STATIM 7000 Operator's Manual

STATIM 7000 Operator's Manual
3. Installation

3.10 Shipping the Unit

When shipping the unit, you will need to empty
any remaining water from system. To do so,
follow these steps:
1. Remove the reservoir and empty its
contents.
2. Re-insert the reservoir to the unit to allow
any remaining water in the unit to drain into
the reservoir.
3. Remove the reservoir and the water filter and empty any remaining water in the
reservoir.
4. Place a water container below the rear of the unit.
5. Pull out the drain tube completely and remove the drain tube plug to empty any
remaining water into the water container.
6. Replace the drain tube plug and push the drain tube back completely.
7. Repack the unit in the original packing materials and include all accessories originally
included with the unit.
8. Specify heated and insured shipping.
Figure 4
10
3. Installation
drain tube