Removing The Plastic Front Cover; Replacing The Plastic Front Cover - Intel MB440LX System Installation Manual

Removing the Plastic Front Cover

See Figure 4-3.
1. Observe the warnings and cautions on page 3, "Safety Guidelines."
2. Remove both side covers and the top cover, and set them aside
(page 80).
3. Remove the two screws from the front cover, and save them.
4. Unsnap the front cover from the chassis, and place it on a smooth
surface so that it doesn't get scratched.

Replacing the Plastic Front Cover

See Figure 4-3.
1. Insert the plastic T-shaped tabs on the bottom front cover into the
T-shaped notches along bottom of the chassis. Then gently press the
cover onto the chassis until all tabs snap into place.
2. Attach the front cover to the chassis with the two screws you removed
earlier, and tighten them firmly (6.0 inch-pounds).
3. Replace the top cover and both side covers.
4. Connect all external cables and power cords to the system. (Some
systems have more than one power cord.)
84
Chapter 4 Working Inside Your System