Board Set; Removing The Termination Board - Intel MB440LX System Installation Manual

Board Set

The system board supports two processor modules, a memory module, and
an RPX module.
! CAUTION
The Pentium II processor is be extremely sensitive to ESD
and always requires careful handling. After removing the
module from its protective wrapper or from the system
board, place it heat sink side down on a nonconductive,
static-free surface. Do not slide the module over any
surface.
If you are upgrading a one-processor system with a second processor, you
must install a voltage regulator and remove the termination board from the
CPU1 slot.

Removing the Termination Board

See Figure 4-5.
1. Observe the warnings and cautions on page 3, "Safety Guidelines."
2. Remove the left side cover (page 80).
3. Press the latches on the Terminator Latching Assembly (TLA) inward.
4. Pull the TLA out of the module retention bracket.
5. Holding the terminator board by its top edge, carefully rock it back and
forth until the edge connector pulls free.
88
Chapter 4 Working Inside Your System