Setpoints Text Abbreviations - GE Multilin 850 Instruction Manual

CHAPTER 4: SETPOINTS

Setpoints Text Abbreviations

850 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL
comparison can only be performed if a logic '1' is provided at the 'RUN' input.
The relationship between a setpoint and input parameter is indicated by the following
symbols: "<" (less than), ">" (greater than), etc.
• Pickup and Dropout Time Delays: Shown as a block with indication of two timers –
the t (Pickup Delay), and t
PKP
• LED Indicators: Shown as the following schematic symbol (X).
• Logic: Described with basic logic gates (AND, OR, XOR, NAND, NOR). The inverter
(logical NOT), is shown as a circle: O
• FlexLogic operands: Shown as a block with a heading labeled 'FLEXLOGIC OPERANDS'.
Each feature produces output flags (operands) which can be used further for creating
logic in the FlexLogic equation editor, or Trip Bus, or can be directly assigned to trigger
an output. The operands from all relay features constitute the list of FlexLogic
operands.
The following abbreviations are used in the setpoints pages.
• A: amperes
• kA: kiloamperes
• V: volts
• kV: kilovolts
• kW: kilowatts
• kvar: kilovars
• kVA: kilo-volt-amperes
• AUX: auxiliary
• COM, Comms: communications
• CT: current transformer
• GND: ground
• Hz: Hertz
• MAX: maximum
• MIN: minimum
• SEC, s: seconds
• UV: undervoltage
• OV: overvoltage
• VT: voltage transformer
• Ctrl: control
• Hr & hr: hour
• O/L: overload
(Dropout Delay).
DPO
SETPOINTS MAIN MENU
4–5