GE Multilin 850 Instruction Manual page 571

CHAPTER 5: STATUS
850 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL
Service Launch Support for
Speed* Programmable
time to live
Configurab Within 2 ms Time to live
le GOOSE (1 CPU programmable
scan)* from 1000 to
60000 ms
* Launch speed is measured by comparing the time stamp in SOE of digital remote output
status change to the time stamp of message seen on the network by a computer who's
clock is synchronized by an IRIG-B card to the same IRIG-B source as the 850 relay.
REMOTE INPUTS
Path:
Status > Communications > Remote Inputs
The present state of the 32 remote inputs are shown here. The state displayed is the
remote point unless the remote device has been established to be "Offline" in which case
the value shown is the programmed default state for the remote input.
GGIO1 INDICATIONS
Path:
Status > Communications > GGIO1 Indications
The present state of the 32 GGIO1 Indications are shown here. There are up to 32 GGIO
indications that can be used to map any FlexLogic operand into the IED 61850 information
model. Default value is Off.
GOOSE STATUS
Path:
Status > Communications > GOOSE Status
GOOSE 1 to 64 Status
Range: OFF, ON
Default: OFF
GOOSE HEADER
Path:
Status > Communications > GOOSE HDR Status
GOOSE 1 to 64 H.Status
Range: OFF, ON
Default: OFF
GOOSE ANALOG
Path:
Status > Communications > GOOSE Analog AV
FLOAT 1 to 24
Range:
Default: 0.0
SINT32 1 to 8
Range:
Default: 0
IEC 61850 STATUS
Path:
Status > Communications > IEC 61850 Status
# of Tx # of Rx Test Bit
Support
3 8 Y
Devices
COMMUNICATIONS
Number of Number of
items in remote
each inputs per
transmissi relay
on or
reception
64 Data 32
Items per
Data Set
5–9