Getting Started - Elcometer E130-S Operating Instructions Manual

Packaging
The gauge is packed in cardboard packaging. Please ensure that this
packaging is disposed of in an environmentally sensitive manner. Please
Consult your Local Environmental Authority for further guidance.

2 GETTING STARTED

Fitting the batteries
Your gauge is supplied with batteries ready to fit. To insert or replace
the batteries:
1. Unscrew and pull-up the retaining screw
then remove the battery compartment cover.
2. Insert 4 batteries (type LR6/AA) taking care
to ensure correct battery polarity.
3. Refit the cover and tighten the retaining
screw.
The battery condition is indicated by a symbol in the top right of the
display:
• Full symbol (orange) = batteries at full capacity
• Empty symbol (red, flashing) = batteries at lowest sustainable level
To maximise battery life, ensure that Auto Screen Brightness is
selected, or the screen brightness is low via Menu/Setup/Screen
Settings/Screen Brightness and the Bluetooth (T) is disabled (if not
being used) via Menu/Bluetooth and uncheck the Enable Bluetooth
radio button.
Fitting the shoulder strap
A shoulder strap is supplied with each gauge. This is fitted by attaching the
clips at either end of the strap to the shoulder strap connection points at the
top of the gauge.
Switching the gauge on/off
To switch on, press on/off key for more than 0.5 seconds.
Ÿ
To switch off, press and hold on/off key until the screen blanks.
Ÿ
The gauge will switch off automatically after 5 minutes of inactivity. To switch
off this feature, press Menu/Setup and then de-select Gauge Auto Off.
5
R
+
+ +
www.elcometer.com
+