Elcometer E130-S Operating Instructions Manual page 27

Appends a '_1' to the original batch name
Ÿ
Opens a new batch - copying all the batch setup and calibration
Ÿ
information
The new batch is named as the original batch, with a '_2'
Ÿ
For example:
A fixed batch is created and named "Component A".
Ÿ
When the batch is full, a new fixed batch 'Component A_2' is
Ÿ
created
'Component A' becomes 'Component A_1'
Ÿ
Appending the batch name in this way allows the user to quickly
identify and linksimilar batches together.
Once a fixed batch size batch has been filled, no additional readings
can be added to that batch; a partially completed fixed batch size
batch, however, can be re-opened and completed at a later date.
To continue a batch link, press Batch/Open Existing Batch and select
the last batch in the link. If the batch is full, the gauge will prompt the user
to open a new batch before continuing. If the batch is partially complete
the user can complete the batch before continuing to a new batch.
When downloading linked batches into ElcoMaster™ 2.0; the original
batch name will be displayed (Component A in the above example).
Selecting this batch name will download all linked batches into
ElcoMaster™ 2.0 at the same time. For more information on
downloading batches see page 28.
Note: Once a fixed batch size batch has been created and data has been stored into
the memory, the user cannot rename the batch name within the gauge. The batch
name can be amended using the ElcoMaster™ 2.0 software.
Exit Batching
To stop using the Batching Mode and return to the Immediate mode
select Batch/Exit Batching.
www.elcometer.com
R
26