Elcometer E130-S Operating Instructions Manual page 7

R
Selecting a language
When the gauge is switched on for the first time after dispatch from
Elcometer, or following a gauge reset, the display will show the language
selection screen:
é
1. Select your language using the softkeys
ê
2. Follow the on screen menus
The language can also be changed via Menu/Setup/Language
To access the language menu when in a foreign language:
1. Switch the gauge OFF
2. Press and hold the left softkey and switch the gauge ON
3. Release the left softkey
é
4. Select your language using the softkeys
ê
Selecting Manual or Auto Screen Brightness Adjustment
When the language has been selected following first switch on, or after a
gauge reset, the display will ask the user to select either a manual or
automatic screen brightness adjustment.
Selecting Manual will guide the user to manually adjust the screen
brightness before returning to the reading screen.
Selecting Auto will enable the gauge to automatically select the
appropriate brightness for the surrounding light conditions using the
gauge's internal light sensor.
Screen brightness can also be changed via Menu/Setup/Screen
Settings/Screen Brightness
Note: Increasing the screen brightness will reduce battery life.
Adjusting the beep volume
Each time a measurement is taken, or during a timer count, the gauge will
beep. The beep volume can be adjusted and can even be switched off via
Menu/Setup/Beep Volume
www.elcometer.com 6