Elcometer E130-S Operating Instructions Manual page 2

Hg
Pb
The Elcometer 130 Model T meets the Radio and Telecommunications Terminal
Equipment Directive. The Elcometer 130 Model S meets the Electromagnetic
Compatibility Directive. This product is Class B, Group 1 ISM equipment according to
CISPR 11. Class B product: Suitable for use in domestic establishments and in
establishments directly connected to a low voltage power supply network which supplies
buildings used for domestic purposes. Group 1 ISM product: A product in which there is
intentionally generated and/or used conductively coupled radiofrequency energy which is
necessary for the internal functioning of the equipment itself.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesired
operation. The Elcometer 130 Model T complies with FCC radiation exposure limits set
forth for an uncontrolled environment. End users must follow the specific operating
instructions for satisfying RF exposure compliance. This transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter. Elcometer 130
Model T: The FCC identifier and the Japanese radio law certification numbers can be
located in the gauge's Regulatory screen found in the following menu structure
Menu/About/Legal/Regulatory.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by Elcometer Limited could void the user's authority to operate the
equipment under FCC rules.
Elcometer 130 Model S: This Class B digital apparatus complies with Canadian ICES-003.
Elcometer 130 Model T: Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. This device
complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
is a registered trademark of Elcometer Limited, Edge Lane, Manchester, M43 6BU. United Kingdom
R
are trademarks owned by Bluetooth SIG Inc and licensed to Elcometer Limited. Bluetooth SIG
QDID = B014393.
All other trademarks acknowledged.
Gauge Dimensions: 250 x 145 x 50mm (9.8 x 5.7 x 1.9"). Gauge Weight: 780g (1.72lb)
© Elcometer Limited 2013. All rights reserved. No part of this document may be reproduced, transmitted, transcribed,
stored (in a retrieval system or otherwise) or translated into any language, in any form or by any means (electronic,
mechanical, magnetic, optical, manual or otherwise) without the prior written permission of Elcometer Limited.
TMA-0578 Issue 01
R
www.elcometer.com