Point-To-Point Configuration - CyberData 011233 Operation Manual

Sip paging adapter

Hide thumbs Also See for 011233:

Table of Contents

2.6.7.1 Point-to-Point Configuration

When the board is set to not register with a SIP server, it's possible to set the device to dial out to a

single endpoint. To do this, do the following:

1. On the SIP page

2. Type the IP address of the remote device that you want to contact into the Dial out Extension

Note

CyberData Corporation

(Figure

2-18), make sure that the Register with a SIP Server parameter is not

selected.

field

Establishing point-to-point SIP calls may not work with all phones.

Figure 2-18. SIP Page Set to Point-to-Point Mode

Device is set to NOT register with a SIP server

931087G

Setting Up the SIP Paging Adapter

Configure the SIP Parameters

Operations Guide

Table of Contents

Do you have a question about the 011233 and is the answer not in the manual?