Point-To-Point Configuration - CyberData VoIP V2 Operation Manual

Poe-voip paging server

Hide thumbs Also See for VoIP V2:

Table of Contents

2.4.6.1 Point-to-Point Configuration

When the board is set to not register with a SIP server, it's possible to set the device to dial out to a

single endpoint. To do this, do the following:

1. On the SIP Configuration page

parameter is not selected.

2. Type the IP address of the remote device that you want to contact into the Dial out Extension

field

Note

CyberData Corporation

The delayed DTMF functionality is available in the Point-to-Point Mode.

Establishing point-to-point SiP calls may not work with all phones.

Figure 2-12. SIP Configuration Page Set to Point-to-Point Mode

Device is set to NOT register with a SIP server

930367H

(Figure

2-12), make sure that the Register with a SIP Server

Setting Up the V2 Paging Server

Configuring the V2 Paging Server

Operations Guide

Table of Contents