CyberData 011233 Operation Manual page 33

2. On the Device page, you may enter values for the parameters indicated in
Note
Web Page Item
Line-in Settings
Enable Line-in to Line-out Loopback
Clock Settings
Set Time with NTP Server on boot
NTP Server
Posix Timezone String
Periodically sync time with server
Time update period (in hours)
Current Time
Misc Settings
Device Name
Beep on Init
Beep on Page
Disable HTTPS (NOT recommended)
Relay Settings
Activate Relay on Local Audio
DTMF Settings
DTMF Duration
Bypass DTMF Menus (Go straight to page)
Send pre-configured DTMF for Analog Zone
Zone
CyberData Corporation
The question mark icon (
after the Toggle Help button is pressed
Table 2-5. Device Configuration Parameters
Description
Line-in audio will play back out the device's audio output ports. This is
the lowest priority audio and will be preempted by any other audio
stream.
When selected, the time is set with an external NTP server when the
device restarts.
Use this field to set the address (in IPv4 dotted decimal notation or as a
canonical name) for the NTP Server. This field can accept canonical
names of up to 64 characters in length.
See
use the Posix Timezone String to specify time zone and daylight savings
time where applicable. Enter up to 63 characters.
When selected, the time is periodically updated with the NTP server at
the configured interval below.
The time interval after which the device will contact the NTP server to
update the time. Enter up to 4 digits.
Allows you to input the current time. (6 character limit)
Type the device name. Enter up to 25 characters.
Device will play the user defined "pagetone" audio file when it boots.
Device will play the user defined "pagetone" audio file before playing a
SIP page.
Disables the encrypted connection to the webpage. We do not
recommend disabling HTTPS for security reasons.
The relay will be activated (closed) when the device is playing audio.
Use this to activate an external amplifier when the device is playing
audio.
The duration, in milliseconds, of DTMF tones played out of the device's
analog audio ports (0-65535).
When selected, the DTMF menu options are bypassed when a page is
sent, and the device begins a live/buffered page no ability to send stored
messages).
When selected, a pre-configured DTMF sequence is sent to activate an
analog zone when
enabled.
Type the pre-configured DTMF sequence for the analog zone.
931087G
) in the following table shows which web page items will be defined
.
Section 2.6.5.1, "Time Zone Strings"
Bypass DTMF Menus (Go straight to page)
Setting Up the SIP Paging Adapter
Configure the Device Parameters
Table 2-5.
for information about how to
setting is
Operations Guide
25