CyberData 011233 Operation Manual page 31

Web Page Item
Note
At this point you can:
•
•
•
•
•
•
•
•
•
Note
CyberData Corporation
Table 2-4. Home Page Overview (continued)
Description
Click on the Reboot button to reboot the system.
Click on the Toggle Help button to see a short description of some of
the web page items. First click on the Toggle Help button, and you will
see a question mark (
Move the mouse pointer to hover over a question mark to see a short
description of a specific web page item.
You must click on the Save button and then the Reboot button for the changes to take
effect.
Review the SIP Paging Adapter's Current Settings. Use the RTFM switch to restore the factory
default settings. See Section 2.5, "Restore the Factory Default
Configure the device parameters. Click on the Device button and see
the Device Parameters".
Configure the network parameters. Click on the Network button and refer to
"Configure the Network Parameters"
Configure the SIP parameters. Click on the SIP button and see
SIP Parameters".
Configure the multicast parameters. Click on the Multicast button and see
"Configure the Multicast Parameters"
Configure the fault detection parameters. Click on the Fault button and see
"Configure the Fault Detection
Configure the audio parameters. Click on the Audiofiles button and see
"Configure the Audio Parameters"
Configure the event parameters. Click on the Events button and see
the Event Parameters" for instructions.
Configure the autoprovisioning parameters. Click on the Autoprov button and see
2.6.12, "Configure the Autoprovisioning Parameters"
Click on the Firmware button any time you need to upload new versions of the firmware.
See Section 2.7, "Upgrading the Firmware"
) appear next to some of the web page items.
for instructions.
for instructions.
Parameters".
for instructions.
for instructions.
931087G
Setting Up the SIP Paging Adapter
Log in to the Configuration GUI
Settings".
Section 2.6.5, "Configure
Section 2.6.6,
Section 2.6.7, "Configure the
Section 2.6.8,
Section 2.6.9,
Section 2.6.10,
Section 2.6.11, "Configure
for instructions.
Operations Guide
23
Section