Restore The Factory Default Settings - CyberData 011233 Operation Manual

2.5 Restore the Factory Default Settings

The SIP Paging Adapter is delivered with factory set default values for the parameters in
Use the RTFM switch (see
factory default settings.
Note
To restore these parameters to the factory default settings:
1. Press and hold the RTFM switch until the status and paging lights come on.
2. Continue to press the switch until after the indicator lights go off, and then release it.
Note
3. The SIP Paging Adapter settings are restored to the factory defaults.
CyberData Corporation
Figure
RTFM Switch
When you perform this procedure, the factory default settings are restored. The default
parameters for access are shown in
Table 2-2. Factory Default Settings
Parameter
IP Addressing
a
IP Address
Web Access Username
Web Access Password
a
Subnet Mask
a
Default Gateway
a. Default if there is not a DHCP server present.
The "Restoring Defaults" announcement can be heard if a speaker or amplified speaker is
connected to the unit.
931087G
Confirm that the SIP Paging Adapter is Up and Running
2-9) on the back of the unit to restore these parameters to the
Figure 2-9. RTFM Switch
Table 2-2.
Factory Default Setting
DHCP
10.10.10.10
admin
admin
255.0.0.0
10.0.0.1
Setting Up the SIP Paging Adapter
Table
Operations Guide
15
2-2.