Restore The Factory Default Settings - CyberData 011280C Operation Manual

2.5 Restore the Factory Default Settings

The InformaCast Enabled Paging Adapter is delivered with factory set default values for the
parameters in
these parameters to the factory default settings.
Note
To restore these parameters to the factory default settings:
1. Press and hold the RTFM switch until the status and paging lights come on.
2. Continue to press the switch until after the indicator lights go off, and then release it.
Note
3. The InformaCast Enabled Paging Adapter settings are restored to the factory defaults.
Operations Guide
Table 2-3. Use the RTFM switch (see
RTFM Switch
When you perform this procedure, the factory default settings are restored. The default
parameters for access are shown in
Table 2-3. Factory Default Settings
Parameter
IP Addressing
a
IP Address
Web Access Username
Web Access Password
a
Subnet Mask
a
Default Gateway
a. Default if there is not a DHCP server present.
The "Restoring Defaults" announcement can be heard if a speaker or amplified speaker is
connected to the unit.
Installing the InformaCast Enabled Paging Adapter
Figure
Figure 2-8. RTFM Switch
Table 2-3.
Factory Default Setting
DHCP
10.10.10.10
admin
admin
255.0.0.0
10.0.0.1
931767B
Restore the Factory Default Settings
2-8) on the back of the unit to restore
CyberData Corporation
14