Participant Control - Polycom RMX 1000 User Manual

Figure 9-6
The parameters displayed on the General, Advanced, and Information tabs are
the same as those for adding a new participant. For explanation on
configuration parameters, see Adding a Participant to the Address Book.
The Connection Status tab shows the status and detailed information of the
participants, including time of connecting/disconnecting, cause of
disconnecting, network transfer rate, packet loss ratio, audio, video, H.239
dual-stream protocol, etc.
The Media Source tab can be used to customize layout for participant's
endpoint after the layout mode is set to Conference Layout.
The Message Overlay tab is used to set the message overlay of the participant's
endpoint. For explanation on the configuration parameters, see Table 9-2
Setting Message Overlay.

Participant Control

You can control and modify the participant's connection status of an ongoing
conference through the buttons in the Participant list pane, the Participant
right-click shortcut menu, and the Participant Properties interface.
The table below explains all the buttons in the Participant list pane.
Table 9-4
Button
Participant Properties
Buttons in the Participant List Pane
Name Description
Define a new participant. For more information about the
New
New Participant dialog box, see Creating a Participant in
Participant
the Address Book.
Connect
Connect a disconnected defined dial-out participant to the
conference.
Participant
Disconnect
Disconnect the participant from the conference.
Participant
Polycom RMX 1000 User Guide
9-9