First Time Installation And Configuration; Hardware Installation And Setup; Configuration Preparations; Obtaining Network Information - Polycom RMX 1000 User Manual

First Time Installation and
Configuration
Follow the procedure below to implement First Time Installation and
Configuration of the RMX 1000 system:
1
2
3

Hardware Installation and Setup

Install the hardware and connect lines as described below:
1
2
3

Configuration Preparations

Obtaining Network Information

Before the first time configuration, obtain the following information from the
network administrator. This helps you to configure the RMX 1000 in your
local network:
Hardware Installation and Setup
Configuration Preparations
― Get the information needed for network configuration.
― Get the product activation key.
First Time Configuration
― Connect a PC to the RMX 1000.
― Log in to the Web interface.
― Modify the default IP address.
― Configure other network options.
Put the RMX 1000 product on a stable surface at the installation site.
Carefully take the RMX 1000 device out of the package. You can install
the device in the rack or position it on an even surface.
― Mount the RMX 1000 in the rack: Install rack brackets, supplied by
the rack manufacturer, in the rack. Mount the RMX 1000 on top of the
rack brackets. Fasten the RMX 1000 to the rack with screws.
― Put the RMX 1000 on a safe, even, and clean surface.
Connect cables on the back panel of the RMX 1000:
― Power Cable: Firmly insert the plug into the power socket to prevent
poor contact.
― LAN Cable: Connect to the LAN1 port of the RMX 1000.
2
2-1