Starting A Conference Using The Remote Control - Polycom RMX 1000 User Manual

Figure 3-6

Starting a Conference Using the Remote Control

To create a new conference directly by the remote control of an endpoint,
enter the dialing number as described in the table below on the remote
control.
Table 3-2
Scenario
Create a conference
which has no
password
Create a conference
which has one
password only
Create a conference
which has both
conference and
chairperson password
Running an Instant Conference
Dialing number for Creating a conference
The conference ID the user enters for creating a new conference must be unique -
different from existing conference IDs.
Dialing Number
RMX 1000 is registered to GK:
[RMX 1000 E.164 Prefix][Conference ID]
RMX 1000 isn't registered to GK:
[RMX 1000 IP Address]##[Conference ID]
RMX 1000 is registered to GK:
[RMX 1000 E.164 Prefix][Conference ID]##[Password]
RMX 1000 isn't registered to GK:
[RMX 1000 IP Address]##[Conference ID]##[Password]
Note: If only one password is entered, it will be defined as a
chairperson password. In this case, there won't be a
conference password and the user will receive the
chairperson abilities.
RMX 1000 is registered to GK:
[RMX 1000 E.164 Prefix][Conference ID]##[Conference
Password]##[Chair Person password]
RMX 1000 isn't registered to GK:
[RMX 1000 IP Address]##[Conference ID]##[Conference
Password]##[Chair Person password]
Note: The conference password and chairperson password
must be different. If the user enters the same password for
both, the call will be rejected.
Polycom RMX 1000 User Guide
3-7