Figure 13. Removing the cable-management-support arm
Replacing the cable-management arm
Replace the cable-management arm after you install the 2145-CG8 or 2145-CF8 node into the rack.
Replacing the 2145-CG8 and 2145-CF8 cable-management arm
|
The SAN Volume Controller 2145-CG8 or 2145-CF8 use a cable-management arm to route and secure
power cables and other cables.
Replace the cable-management arm after you replace the node in the rack.
To attach the cable-management arm, perform the following steps:
1. At the rear of the rack, install the cable-management-support arm.
Insert both ends of the cable management support arm into the slide rail, as shown by Figure 14 on
page 31.
30
IBM SAN Volume Controller Hardware Maintenance Guide