Table 12. Distinctive characteristics of the SAN Volume Controller 2145-8G4 versions (continued)
Rev 1 version
Has two microprocessors
Has eight memory modules
Has a serial number in the format mm-Fxxxx
The following tables identify part numbers and provide brief descriptions of the SAN Volume Controller
2145-8G4 parts. Use the assembly index number to locate and identify the parts that are shown in
Figure 4 on page 13.
v Table 13 lists the parts that are unique for the Rev 1 version.
v Table 14 lists the parts that are unique for the Rev 2 version.
v Table 15 lists the parts that are used with both versions.
v Table 16 on page 15 lists the FRUs that are not referred to by any SAN Volume Controller 2145-8G4
service procedure.
Table 13. FRU part numbers that are unique for the SAN Volume Controller 2145-8G4 Rev 1 version
Assembly index
-2
-3
Table 14. FRU part numbers that are unique for the SAN Volume Controller 2145-8G4 Rev 2 version
Assembly index
-2
-3
Table 15. FRUs in the SAN Volume Controller 2145-8G4 parts assembly
Assembly index
-1
-4
-5
-6
-7
14
IBM SAN Volume Controller Hardware Maintenance Guide
Part number
42C4228
39M5784
Part number
44R5646
39M5790
Part number
43W0609
31P0937
32R2883
31P1090
39Y7189
Rev 2 version
Has one microprocessor
Has four memory modules
Has a serial number in the format mm-Gxxxx
Units
2
8
Units
1
4
Units
1
1
1
1
1
Description
Microprocessor, 2.33 GHz
with heat sink
Memory, 1 GB ECC DRR2
Description
Microprocessor, 2.5 GHz
(You need 1 alcohol wipe
and 1 thermal grease
syringe when you replace
this FRU. If you do not
already have these, order
them before you begin to
replace the part.)
Memory, 2 GB ECC DRR2
Description
Top cover
4-port Fibre Channel host
bus adapter
Riser card, PCI Express
(Slot 1)
System board (You need 2
alcohol wipes and 2
thermal grease syringes
when you replace this FRU.
If you do not already have
these, order them before
you begin to replace the
part.)
Power supply, 670 watt