Cable Management Arm Box Contents - IBM Storwize V7000 Unified Quick Installation Manual

– Minimum depth of 70 mm (2.76 inch) between the front mounting flange and
inside of the front door.
– Minimum depth of 157 mm (6.18 inch) between the rear mounting flange and
inside of the rear door.
– Minimum depth of 718 mm (28.27 inch) and maximum depth of 762 mm (30
inch) between the front and rear mounting flanges to support the use of the
cable management arm.
Note: The maximum distance between the front and the rear EIA rails of the
rack is 810 mm (31.9 inch). Also, cage nuts and clip nuts are not required to
install the file module in a rack cabinet.
v Install the cable management arm on either side of the file module. These
instructions are shown with the cable management arm mounted on the left
side. The installation instructions in this document can be reversed if you are
installing the cable management arm on the side of the file module not shown.
The following illustration shows the items that you need to install the file module
in the rack cabinet. If any items are missing or damaged, contact your place of
purchase. The contents from the slide rail box and the cable management arm box
are necessary for this installation.
Cable management
support arm
Cable ties or
hook and
hook fasteners
Figure 18. Cable management arm box contents.
Cable management
arm assembly
Large cable
tie or hook
and loop strap
Chapter 2. Performing the hardware installation
35