5. Remove the air baffle (
corners and lift it up out of the node.
Figure 254. SAN Volume Controller 2145-8A4 air baffle and heat-exchanger assembly
6. Open the heat-exchanger-assembly release latch (
7. Lift the side of the heat-exchanger assembly (
node, slide it toward the middle of the node slightly, and lift the entire assembly out of the node.
8. Open the microprocessor release latch to the fully open position.
1
in Figure 254). Grasp the air baffle by the leftmost and rightmost rear
3
2
in Figure 254) to the fully open position.
in Figure 254) that is closer to the middle of the
Chapter 2. Removing and replacing parts
255