Figure 73. Left release button of a 2145-CG8 or 2145-CF8 service controller
7. Gently press both release buttons, shown by 2 in Figure 74, and release the catch while pulling
|
gently forward on the service controller.
|
The service controller moves slightly forward.
|
|
Figure 74. Service controller for the 2145-CG8 or 2145-CF8 with attached USB cable
1 Service controller
|
2 Service-controller release buttons
|
3 USB service-controller cable
|
|
Attention: If you meet any resistance, do not pull harder, or you might damage the release
mechanism.
|
Stop pressing the release buttons once the service-controller locking mechanism clears the 2145-CG8
|
|
or 2145-CF8.
|
8. Pull the service controller fully out of the frame.
If you are replacing a hot-swap drive, you can leave the service-controller cable attached to the
|
service controller. Rest the service controller on another surface while removing and replacing the
|
|
drive to prevent strain on the cable.
9. If you are intending to replace the service controller FRU, detach the USB cable, shown by 3 in
|
Figure 75 on page 88, from the service controller.
|
|
1
2
3
2
1
Chapter 2. Removing and replacing parts
87