Estimating The Position Of The Thermal Grease; Complete Set Of Nine Thermal Grease Dots On - IBM SAN Volume Controller 2145-CG8 Hardware Maintenance Manual

Figure 297. Estimating the position of the thermal grease dots
b. For each dot of thermal grease, use two divisions on the syringe scale, which is 0.02 ml of grease.
You will use about half the syringe contents for the nine dots. Figure 298 shows how the
microprocessor appears with the nine dots of grease.
Figure 298. Complete set of nine thermal grease dots on the microprocessor
c. Install the heat sink by gently squeezing it down onto the thermal grease and then tightening the
four retaining screws alternately and evenly.
7. If this is a Rev 1 node, repeat steps 5 on page 295 and 6 on page 296 for the second microprocessor
and heat sink. If this is a Rev 2 node, continue with the next step.
8. Replace either eight memory modules for the Rev 1 node or four memory modules for the Rev 2
node. See "Replacing the memory modules (DIMM)" on page 109.
9. Replace the right air baffle, which is shown in Figure 299 on page 298.
a. Locate the pin on the bottom of the air baffle in the locating hole on the system board.
b. Push the baffle backwards to locate it in place.
Chapter 2. Removing and replacing parts
297