Table of Contents
Advertisement
6. If you are not replacing the 10 Gbps Ethernet riser-card assembly, be sure to install one of these other
|
|
two cards that must be used in the PCI slot 2 connector. If you do not have a riser card, you can
disassemble the 10 Gbps Ethernet riser-card assembly to use the riser card from the assembly.
|
7. Place the Ethernet riser-card assembly on a flat, static-protective surface.
|
8. If you are instructed to return the 10 Gbps Ethernet riser-card assembly, follow all packaging
|
|
instructions, and use any packaging materials for shipping that are supplied to you.
Replacing the 10 Gbps Ethernet riser-card assembly
|
An IBM authorized service provider can replace the 10 Gbps Ethernet riser-card assembly.
|
Take precautions to avoid damage from static electricity. Wear an anti-static wrist strap and use a
|
|
static-protected mat or surface. For more information, see "Handling static-sensitive devices" on page xx.
Replacing the 2145-CG8 10 Gbps Ethernet riser-card assembly
|
An authorized IBM service provider can replace the 10 gigabits per second (Gbps) Ethernet riser-card
|
|
assembly into the SAN Volume Controller 2145-CG8 node.
DANGER
|
|
Multiple power cords. The product might be equipped with multiple power cords. To remove all
hazardous voltages, disconnect all power cords. (L003)
|
|
| |
| |
| |
1
2
|
|
|
|
|
Figure 191 shows the connectors on the rear of the SAN Volume Controller 2145-CG8:
|
|
1 2
3 4
|
|
Figure 191. Connectors on the rear of the SAN Volume Controller 2145-CG8
|
1 Fibre Channel port 1
|
2 Fibre Channel port 2
|
3 Fibre Channel port 3
|
4 Fibre Channel port 4
|
5 10 Gbps Ethernet port 1
|
194
IBM SAN Volume Controller Hardware Maintenance Guide
or
5
6
9
11
10
or
1
2
7
8
4
3
2
1
- Quick Links:
- San Volume Controller 2145-Cg8 Parts
Hide quick links:
Advertisement
Table of Contents
