Compact Flash Memory Use On The Mgc - Polycom DOC2238A Hardware Installation Manual

Chapter 2 - Hardware Installation

Compact Flash Memory Use on the MGC+

2-40
The Main Control Unit's Compact Flash port is used to perform the following
tasks:
• pSOS Rescue Disk
— Contact you next level of support
Swapping the Operating System (OS)
•
Contact your next level of support
—
First Entry MGC+ Control Unit (CU) IP Configuration using:
•
pSOS OS
—
XPEK OS
—
The Compact Flash slot is located on the Main Control Module, below the
Flash Memory LED. When the Flash Memory is active, the LED
flashes.
Flash Memory Card
R
MGC+
Power
In Out
Do not press the Reset button or turn the system OFF while the Flash Memory
LED is flashing.
Eject Button
Power Power
In Out In
Line 1
Line 2
Line 3
Line 4
Line 1 Line 5
Line 2
Line 6
Line 3
Line 7
Line 4 Line 8
Out