Polycom DOC2238A Hardware Installation Manual page 33

Table 2-2: MGC+ Power Setting During ReadiManager IAM Blade Installation
MGC+ Power
Do This
Setting
ON 1
2
3
Note: If you did not follow this procedure and installed the
ReadiManager IAM prior to installing the I/O card for the
ReadiManager IAM, then:
4
5
MGC+ Hardware and Installation Manual
Remove the rear I/O panel and install the I/O card on
the chassis.
See "Installing the I/O Card for the ReadiManager
IAM" on page 2-15.
Remove the ReadiManager IAM front panel.
See "Removing the Blank Panel from the MGC+ Unit"
on page 2-14.
Install the ReadiManager IAM.
See "Inserting the ReadiManager IAM into the MGC+
Unit" on page 2-16.
The ReadiManager IAM automatically starts/boots
when inserted into its slot on the backplane.
Turn the ReadiManager IAM OFF, by pushing the
SHUT Down button.
Turn the ReadiManager IAM ON, by pushing the
SHUT Down button again.
2-13