Fan Replacement For The Mgc+100 - Polycom DOC2238A Hardware Installation Manual

Fan Replacement for the MGC+100

The fans are hot swappable and can be replaced with the system running. The
fans are located on the rear panel of the MGC+100. Use the following
procedure to replace a faulty fan:
1. Disconnect the cable to the fan.
2. Unscrew the four screws on the rear panel of the MGC+100 that secure
the fan.
3. Remove the fan.
4. Position the replacement fan correctly on the rear panel.
5. Tighten the four screws on the rear panel of the MGC+100 that secure
the fan.
6. Connect the cable to the fan.
MGC+ Hardware and Installation Manual
5-15